AU - 1008 B Electronic Tearing Resistance Tester
Electronic Tearing Resistance Tester with standard medium ‘B'
pneumatic clamping of the test pieces, automatic calculations through Microprocessor and presentation of measured value, all of which ensure accurate and stable test results.
Extra Optional:
Interchangeable
for different range.
- 0-2000, (Extra Light)
- 0-8000, (Light, A)
- 0-16000 mN. (Medium, B)
- 0-32000 mN. (Heavy, C)
- Tearing sample cutter
- Set of calibration weights.
Spesification
SPECIFICATIONS
The instrument is easy to use, with an easy-to-read display.
Pneumatic clamping and pendulum release gives stable, accurate and reproducible results stable and accurate, regardless of operator.
Calculations, calibrations, internal tests, zero setting, pendulum release and presentation of results are all handled by the built-in Microprocessor.
Easily interchangeable pendulums.
One pendulum A (light), B (Medium) or C (Heavy) according to table is included as per order.
Each pendulum is delivered with one check weights.
Easy to calibrate using the dead weights.
The results is presented as the individual Tearing Resistance, Tearing Index and Tear factor on an alpha-numeric display.
Measuring Units |
: mN/gram force. |
Accuracy |
: Deviation = ± 1% of reading but not better than 0.25% of nominal measuring range. |
Power consumption |
: 50 W. |
Power Supply |
: Single Phase 220 V, 50 Hz. |
Max. Tearing capacity |
: see table below. |
Pendulum |
Pendulum A
|
Pendulum B | Heavy C | Test Piece torn |
maximum tearing |
8000 mN |
16000 mN 1600 (gf) |
32000 mN 3200 (gf) | 1 |
Extra Heavy C capacity 64000 mN.
Pneumatic type sample cutter
Shipping Data |
Ordering Data |
Net Weight |
Model No |
Gross weight |
Voltage |
Dimension |
Frequency |
Changes:
UEC products undergo continuous development. The technical data in this catalogue are therefore subject to change
Inquiry
Video
Tidak ada video untuk produk ini